Tangent points table

 

The indicated button allows a tangent point table to be placed in the drawing. This may also be done on a Layout.

A location is requested where the table will be placed.

In addition to a table, symbols are also placed in the longitudinal section and along the trace where these points are located:

The tangent points are sequentially numbered for both horizontal and vertical tangent points as seen from the entry point.

 

Coordinates only

It is possible to show only coordinates in the tangent point list. This can be set in the settings.

 

Waypoints

In the settings it is also possible to indicate that extra distances are shown as waypoints in the list. An abbreviation for this can also be set. The points are automatically numbered, just like the tangent points.