Display

 

On the 'Display' tab, settings can be made for the display of properties and objects:

 

Units and precision

It is possible to display slope angles in degrees or percentages. Likewise, the number of decimal places can be set here.

 

Labels

The name of the drill can be shown in the corresponding labels. The labels can also be placed perpendicular to the trace, and entry and exit angle labels can be shown.

 

Longitudinal sections

When placing a Profile View, it is not yet known how much design space is needed for the drill, because it has not yet been specified how deep it should be. To set enough space, a default value can be set here for above ground and below ground. Sufficient design space can be set, the height of the Profile View can be automatically reduced during finalization. Labels in the Profile View can be aligned to top.

 

Band Sets

In the bands below the Profile View, values can be shown along a set spacing, at the tangent points and at additional set distances. Titles of the bands can be shown either on the left or on both sides, and the information bands (length, radius, angle) can be placed at bottom or at top of the band set.

 

Tables

An expanded tangent point table can be used instead of a simple one. In the simple variant only the coordinates are shown, in the extended variant the radii and lengths are also shown. The table can also display extra distances, this allows own waypoints to be included.

 

As-builts

The borehole can be hidden in as-built Profile Views. It is usually no longer of interest at this stage.